Full Process Flow Diagram
Click on equipment to see principles and load; swipe left-right on narrow screens to view the full diagram. Dashed particles indicate flow direction.MDEA Absorber
The circulating amine solution absorbs acidic gases; effective removal capacity is jointly limited by circulation rate, workload difference, and regeneration heat.
Operating trends · share simulation clock with process
Product composition and H₂S dual coordinates, simultaneously observe desulfurization, CO₂ removal, and drying status.
The right axis for H₂S and the left axis for composition have different dimensions; automatic scaling is used to observe low concentration changes. Gas phase composition is adjusted based on quasi-steady-state response, TSA follows inventory over time; the high-pressure dew point is an ideal conversion without considering compression condensation.
Vehicle CNG quality inspection
Using the current specifications of GB 18047—2017; calculated items and items to be inspected are listed separately.
| Check Items | Simulation results | Determination Caliber | Current state |
|---|
Adsorption → Heating → Cooling → Standby
Continuous accumulation of bed water inventory; low-temperature regeneration or overload may cause early breakthrough in the next cycle.
In this model, the first 50% of the cycle is set as heating, the next 35% as cooling, and the last 15% as standby. Switching is performed according to the demonstration timer, but in practice must be confirmed by temperature, pressure, valve position, and outlet dew point. Regeneration gas uses an independent closed-loop cycle with condensate drainage, and average purge gas loss is listed separately; closed-loop wet gas dynamics are not established.
Every stream of gas has a destination
Dry basis Nm³/h, 0°C, 101.325 kPa; water is listed in a separate ledger.
| Flow stock | Total Gas Volume | CH₄ | CO₂ | H₂S | N₂ | O₂ |
|---|
The H₂S captured by the dry method tower is accounted for based on the equivalent amount in the original gas. Sulfur remains in the medium and is disposed of when the medium is replaced; it does not indicate continuous gas emission. The sulfur carried by MDEA acid gas and the sulfur captured by the dry medium are closed separately. Acid gas, waste gas, and off-spec gas are all directed to the pending confirmation treatment interface, without assuming direct discharge. Methane loss is not included in the qualified product.
Separate view of electrical and thermal consumption
Compression, motor, and pump are idealized estimates; not equal to equipment nameplate power or project guaranteed value.